Hi, when I did `make run_analog PART=1` , I keep g...
# mpw-2-silicon
s
Hi, when I did
make run_analog PART=1
, I keep getting this error showing
fail to receive ready signal from firmware
. I looked at the previous thread and know this is the Nucleo board problem. However I couldn't find the solution to that. Does that mean the only thing I can do is to either change the Nucloe board or test the chip without the board?
It’s solved. It turns out that I just have to press the hat deeper…
t
Just don't press it too far. Getting it just right is a bit of a challenge.
s
Got it! Thank you!