open-source-silicon.dev

image.png

Hello. I want to check my comparator's offset. so, I want to run mc simulation.
but I don't know how to do mc_simulation collectly and to plot the figure.
I try to do simulation like attatched image.

 I think it simulated. How can I check all output using plot?
or How can I plot the file named `test_mc_model.raw` ?
I appreciate for your help.

After the write comand put a '`set appendwrite`' command, otherwise the last write clears the previous ones. At the end of the sim do a `plot all.v(outp)`,
so put the plot command after the `end` of the repeat loop and change to `plot all.v(outp)`

<@U01819B63HP> Thank you for your advice!

<@U01819B63HP> I have one question. If I use `all.v(outd)` as you suggested, all names will come out as out. I want to see it separately. Is there any way to check without entering all names individually, such as `ran1.v(outd)` and `tran2.v(outd)`?

1.png

I think the only other option is just what you said: plot tran1.v(oute) tran2.v(outd)...
Xschem in its internal graphs uses a similar approach, where outp references all the plots, and displayed as a single waveform, outp%0, outp%1, outp%2 use the specified run (first, second, third).